intake manifold

1. When there is vacuum in the intake manifold, the vacuum holds the diaphragm up.
   当进气歧管有真空存在时，真空便向上吸引膜片。
2. The company has many years of production muffler intake manifold assembly, bellows, metal hose of professional experience.
   公司有多年生产消声器进气管总成、波纹管、金属软管的专业经验。
3. Disconnect the spring band clamp from the intake manifold and slide it onto the hose for the ambient air valve.
   将弹簧卡箍从进气管上断开，并将弹簧卡箍滑到大气阀的软管上。
4. The intake manifold connects the carburetor to the intake ports of the engine.
   进气歧管把发动机进气道口连接起来。
5. This device, called the manifold heat-control valve, is built into the exhaust and intake manifold.
   这种装置称为歧管热控制阀，它拼装在排气与进气歧管中。
6. Fit the intake manifold on the turbocharger using a new screw-type clamp.
   用新的螺旋式卡箍在涡轮增压器上安装进气管。
7. Remove intake manifold bolts.
   拆下进气歧管螺栓。
8. Degrease intake manifold flange on the hot-film mass air flow sensors and inner intake manifold.
   除去热膜式空气质量流量传感器上的进气管法兰以及内部进气管上的润滑脂。
9. Research on Plastic Air Intake Manifold Based on DFA
   基于可装配性分析的塑料进气歧管设计研究
10. Install the intake manifold ( refer to Group 11, Exhaust System and Intake Manifold).
    安装进气歧管（见单元11-排气系统和进气歧管）。
11. Fault Description ( reason): High voltage detected at intake manifold pressure sensor signal pin.
    故障描述（原因）：检测到进气歧管压力传感器信号电压值高。
12. On a typical in-line six-cylinder engine the carburetor is located on the intake manifold between cylinder 3 and 4.
    在标准的六缸直列式发动机上，化油器被设置在进气歧管上3号和4号缸之间。
13. Material selection and process discussion of vacuum casting in automotive air intake manifold
    汽车进气歧管真空注型材料选用和工艺探讨
14. Loosen the intake manifold clamp at the turbocharger.
    松开涡轮增压器处的进气管卡箍。
15. Loosen intake manifold on throttle housing.
    松开节气门壳体上的进气歧管。
16. Install cylinder head, intake manifold, and exhaust manifold, refer to cylinder head installation in this section.
    安装汽缸盖，进气歧管和排气管，请参阅本部分的汽缸盖安装。
17. If the electropneumatic shift valve is not activated, the variable intake manifold remains in power position.
    如果没有激活电动气动换档阀，则可变进气管处于功率位置。
18. The throttle body is usually located between the air filter box and the intake manifold, and it is usually located near the mass airflow sensor.
    节气门体之间通常是位于空气滤清器箱和进气歧管，通常是位于大规模气流传感器。冷空气摄入量和它如何运作的。
19. Ultrasonic welding machine can attain to bonding automotive parts, such as intake manifold, instrument panels, tail lights and bumpers, etc.
    臻能超声波焊接机可接合汽车部件，例如进气歧管、仪表板、尾灯及保险杠等；
20. If the engine backfires, the sudden pressure in the intake manifold forces the valve back.
    如果发动机回火，进气歧管骤增的压力就迫使阀门向后移动。
21. Compared to a conventional intake manifold, the distributor pipe of the expansion intake system is longer and has a smaller diameter, while the intake ports are shorter.
    与传统进气管相比，新款车膨胀进气系统的分配器管较长，直径较小，而进气口较短。
22. If you suspect that the variable intake manifold is defective, check that the correct hoses are used for the control valve.
    如果怀疑可变进气管有问题，请检查控制阀是否使用了正确的软管。
23. Simulation Study on Charge Unevenness for Air Intake Manifold Construction
    进气歧管结构对进气不均匀性影响的仿真研究
24. Vibration Test Failure Analysis on Engine Plastic Intake Manifold and Improvement Study
    发动机塑料进气歧管振动试验失效分析与改进研究
25. Remove intake manifold, yoke retainer and aligning yokes.
    拆下进气歧管、叉臂轭护圈，并对正叉臂轭。
26. The pudding results from the failure of all the fuel to vaporize and from the sorting effect of the intake manifold.
    积洼是全部燃料蒸发得不充分和进气歧管类似影响的结果。
27. The effect of installing the Helmholtz resonator in CA488 engine air intake manifold on engine performances is also analyzed in this paper.
    并分析了在CA488进气管中装入亥姆赫兹谐振器对发动机性能的影响。
28. When the engine is shut off, the intake manifold cools and a slight vacuum forms as a result.
    这是因为当发动机熄火时，进气歧管冷却而产生轻微的真空。
29. The air filter is usually located in the air stream to your throttle valve assembly and intake manifold.
    空气滤清器通常位于空气流到你的节流阀总成和进气歧管。
30. In Porsche sports cars, fuel is injected into the intake manifold while the intake valves are open.
    在porsche跑车中，进气门处于打开状态时，燃油将喷射到进气管中。

noun

1. a manifold consisting of a pipe to carry fuel to each cylinder in an internal-combustion engine